Inside the Appliance

Inside a 1995 Maytag Washer: How Washers Worked Before Electronic Controls

A look at how washers used to be built, from Ross, owner of Bobs Appliance.

This is a 1995 Maytag Dependable Care Plus top-load washer: heavy duty, 2 speed, super capacity. It was made in January 1995, so it's almost 32 years old. There aren't many like it left, so here's a look at how washers used to be built.

A 1995 Maytag Dependable Care Plus top-load washer, lid closed, with its control panel
A Maytag Dependable Care Plus washer, made in January 1995.
Maytag control panel with water temperature and extra rinse switches, Infinite Water Level slider, wash and spin buttons, and the timer dial
The control panel.
Close-up of the Infinite Water Level slider, from extra small to extra large
The Infinite Water Level control.

The timer

The washer's mechanical timer, with its small motor at the top and a Maytag label on the side
The timer.

Inside the timer are several small switch contacts that open and close to run each part of the wash: fill, agitate, drain, rinse and spin. A little motor slowly turns a sturdy plastic wheel called a cam. Raised spots on the cam push the contacts closed at just the right points in the cycle, sending power to whichever part needs to run, like the water valve or the drive motor. The timer only controls the order and timing of each step. Other switches handle the rest, like the water level switch that decides when the tub is full.

Inside the washer's console: switches and wiring, with the timer near the bottom
Inside the console, with the timer near the bottom.

The drive motor

Washer cabinet opened up, showing the tub, the drive motor at lower left, and the drain pump at lower right
Under the tub, with the drive motor at lower left and the drain pump at lower right.

The drive motor does most of the heavy lifting. It turns the transmission with one belt and the drain pump with its own belt. The motor runs one direction to agitate, then reverses for drain and spin. When it reverses, the transmission releases its brake and locks up so the whole basket spins. There's no separate shifting part. When spin ends, a spring sets the brake again and the basket stops.

The washer's drive motor under a clear plastic cover, with its warning label
The drive motor.
The transmission under the tub, with the Maytag logo on its cover
The transmission.
The drain pump seen from above, with its hoses attached
The drain pump.

In the tub

Looking down into the washer tub at the agitator
The tub and agitator.
The agitator at work.

Newer washers

Newer washers replace the motor-and-cam timer with an electronic control board, a small computer that runs stored programs, reads sensors, and switches parts on and off.

We repair washers. See our washer repair page.

Reviews

4.9 stars from 328 Google reviews (as of Nov 2026). 100% recommend on Facebook (95 reviews).

A few of our reviews, quoted as written.

Fixed my washing machine in under and hour and stayed with me to make sure everything worked and tested well! Highly recomend

★★★★★ Matthew Jahn, on Google

Showed up on time. Quickly identified the problem with our 10 year old LG washer. He had the replacement part with him. Fixed and tested quickly. My washer works!

★★★★★ Stephen, on Google

Have an Older Washer That Needs Work?

Call the office to set up a visit. Office hours are Monday to Friday, 8:00 AM to 4:30 PM.